70
10) Close the base unit cover and secure with a piece of tape or a large rubber band.
11) Place the instrument in a vinyl or cloth bag to prevent scratches to the surface.
12) Place the custom-cut foam pieces over the instrument.
13) Gently lower the instrument into its box.
14) Place foam pieces as needed to pad the bottom of the instrument.
15) The power supply, small accessories and cables may be contained within a small box and
packed with the
flexiVent
as long as there is adequate padding between it and the
flexiVent
.
5.7.2 PACKING A MODULE SEPARATELY
If your instrument includes multiple modules, or if a module must be shipped separately (e.g. for
module maintenance service), it may be necessary to pack a module on its own. To pack a
module separately, proceed as follows:
1) Remove the module from the base unit per the instructions in section 2.6.2.
2) Carefully disconnect the piston/cylinder set from the module. Not all modules attach to the
piston/cylinder the same way. Refer to the module-appropriate instructions below to
complete this step.
To Next Page
Loading...