Scireq flexivent - Module 4 or 5 Disassembly

73
11) Place the module in an appropriately sized box with 4-6” of padding on all sides.
12) Place the cylinder in the box such that it is padded on all sides and does not move about.
FX Modules 4 and 5:
3) Gently rotate the cylinder counter-clockwise per Figure 5-8.
4) Gently pull the cylinder back from the module.
5) Locate the O-ring that is seated between the cylinder and module. Place the O-ring into a
container (e.g. envelope or small plastic bag).
FIGURE 5-8: MODULE 4 OR 5 DISASSEMBLY
6) Wrap bubble wrap or foam around the piston per Figure 5-4.
7) Wrap entire assembly with hard plastic or pliable metal per Figure 5-6.