Scireq flexivent - Assembly Steps, FX Modules 1,2 and 3

35
2.6.1.1 FX MODULES 1, 2 AND 3
FIGURE 2-6: ASSEMBLY STEPS, FX MODULES 1, 2 AND 3
5) Align the O-ring and the piston/cylinder assembly with the module per Figure 2-6.
6) Insert screws to hold the piston/cylinder in place
This step requires a 7/64” hex/allen wrench.
Screws should be secure, but do not over-tighten them, as this may cause damage.