The instrument type and instrument configuration settings of the .con file and the required setup for the
SEATERM.ini file for the CTD as delivered are documented below. The calibration coefficients for the CTD's
sensors are contained in the calibration coefficient section of the CTD manual.
NOTE:
SEATERM will not upload data correctly without a properly configured SEATERM.ini file. SEASAVE and SBE
Data Processing will not interpret the data correctly without the correct .con file.
SEASOFT CONFIGURATION:
The correct instrument type for your instrument is SBE 19plus V2 SEACAT Profiler. The correct settings for the configuration of
your instrument as delivered are documented below:
Strain Gauge
None
3. Count Pressure, Strain Gauge
4. A/D Voltage 0 Oxygen, SBE 43
5. A/D Voltage 1 OBS, Seapoint Turbidity
6. A/D Voltage 2 Fluorometer, WETLAB ECO-AFL/FL
7
To Next Page
Loading...