Sea-Bird Electronics SBE 19plusV2 - Section 4: Deploying and Operating SBE 19 plus V2; Sampling Modes

To Next Page

To Previous Page

Section 4: Deploying and Operating SBE 19plus V2

Section 4: Deploying and Operating

SBE 19plus V2

This section includes discussions of:

• Sampling modes (Profiling and Moored), including example sets

of commands

• Pump operation

• Real-time setup

• Timeout description

• Command descriptions

• Data output formats

• Optimizing data quality for Profiling applications

• Installing anti-foul fittings for Moored applications

• Deployment

• Acquiring real-time data with SEASAVE

• Recovery - physical handling and uploading data

• Processing data

Sampling Modes

The SBE 19plus V2 has two sampling modes for obtaining data:

• Profiling mode

• Moored mode

Descriptions and examples of the sampling modes follow. Note that the

19plus V2 response to each command is not shown in the examples. Review

the operation of the sampling modes and the commands described in

Command Descriptions before setting up your system.

Note:

Separate software manuals on

CD-ROM and Help files contain

detailed information on installation,

setup, and use of Sea-Bird’s real-

time data acquisition software and

data processing software.

Notes:

• The 19plus V2 automatically enters

quiescent state after 2 minutes

without receiving a command.

•

Set OutputFormat=0 if you will be

using Sea-Bird’s real-time data

acquisition software (SEASAVE)

to view real-time data.