Section 4: Charger Maintenance
13
Section 4: Charger Maintenance
The charger uses two fuses. If one fuse blows, Sea-Bird recommends
that you replace both fuses. The charger has a storage compartment for
spare fuses.
To access the fuses and spares:
1. Unplug the power cable from the charger.
2. Insert the end of a screwdriver into the slot, and pry the fuse compartment
out of the charger.
3. Using the tip of a screwdriver, gently push the spare fuses out of the fuse
holder. Remove each spare from its individual holder. Place new spares in
the individual holders, and replace the holders.
4. Remove the blown fuses, and replace with the spares.
5. Replace the fuse holder in the charger.
Push
spare
fuses
out of
holder
Remove
blown
fuses as
shown
WARNING!
Do not open the fuse
compartment without
unplugging the power cable
from the charger.
137
To Next Page
Loading...