SYSTEM CONFIGURATION 11 February 2009
Model SBE 19plusV2 S/N 19P53231-6266
Instrument Type SBE 19plusV2 SeaCaT Profiler
Firmware Version 2.1
Communications 4800 baud, 8 data bits, no parity, one stop bit
Memory 64MB
Housing 600 meter (Acetron Plastic)
0 Conductivity Raw Frequency 2534.35 Hz
Pressure Sensor Strain Gauge: 350 dBar, S/N 2863051
Computer communications (Data I/O) connector Located on the P/N 17709 Y-Cable
Number of Voltages Sampled: 3
Serial RS-232C Sensor None
Data Format:
Count Temperature
Frequency Conductivity
Count Pressure, Strain Gauge
Stored Voltage 0 (External Voltage 0) Oxygen, SBE 43
Stored Voltage 1 (External Voltage 2) OBS, Seapoint Turbidity
Stored Voltage 2 (External Voltage 4) Fluorometer, WETLAB ECO-AFL/FL
Pump (SBE 5P) 055194
DO Sensor (SBE 43) 431571
Seapoint Turbidity Meter 11826
Fluorometer (WETLabs - ECO-FLRT) FLRT-1299
Individual Voltage Delay Settings for Moored Mode Applications:
SBE 43 30 Seconds
Additional Sensor(s) 4 Seconds
Configured Overall Voltage Delay Setting: 30 Seconds
Note: The 30 second voltage delay for the SBE 43 is based on the typical response time at 2 degrees Celsius for
a 0.5-mil thick membrane to read within 1% of its final value. Please consult Application Note 64 under Summary
of Response Times for Moored Applications for more information.
Note: Overall Voltage Delay Setting is based on the longest time delay listed above. To recalculate this value
when adding or removing sensors, please refer to manual text.
5
To Next Page
Loading...