Sea-Bird Electronics SBE 19plusV2

To Next Page

To Previous Page

Section 4: Deploying and Operating SBE 19plus V2

Status Commands (continued)

Example: 19plus V2 in Profiling mode (user input in bold, command used to modify parameter in parentheses)

getcd

<ProfileMode> [MP]

<ScansToAverage>1</ScansToAverage> [NAvg=]

<MinimumCondFreq>3000</MinimumCondFreq> [MinCondFreq=]

<PumpDelay>60</PumpDelay> [PumpDelay=]

<AutoRun>no</AutoRun> [AutoRun=]

<IgnoreSwitch>no</IgnoreSwitch> [IgnoreSwitch=]

</ProfileMode>

<Type>alkaline</Type> [BatteryType=]

</Battery>

<ExtVolt0>yes</ExtVolt0> [Volt0=]

<ExtVolt1>no</ExtVolt1> [Volt1=]

<ExtVolt2>no</ExtVolt2> [Volt2=]

<ExtVolt3>yes</ExtVolt3> [Volt3=]

<ExtVolt4>no</ExtVolt4> [Volt4=]

<ExtVolt5>no</ExtVolt5> [Volt5=]

<SBE38>no</SBE38> [SBE38=]

<GTD>no</GTD> [GTD= or DualGTD=]

</DataChannels>

<EchoCharacters>yes</EchoCharacters> [Echo=]

<OutputExecutedTag>no</OutputExecutedTag> [OutputExecutedTag=]

<OutputFormat>converted decimal</OutputFormat> [OutputFormat=]

<OutputSalinity>no</OutputSalinity> [OutputSal=]

<OutputSoundVelocity>no</OutputSoundVelocity> [OutputSV=]

<OutputSigmaT-V>no</OutputSigmaT-V> [OutputUCSD=

]

</ConfigurationData>

Example: 19plus V2 in Moored mode, with strain-gauge pressure sensor (user input in bold, command used to modify parameter in parentheses)

Getcd

<MooredMode> [MM]

<SampleInterval>15</SampleInterval> [SampleInterval=]

<MeasurementsPerSample>1</MeasurementsPerSample> [NCycles=]

<Pump>run pump during sample</Pump> [MooredPumpMode=]

<DelayBeforeSampling>0.0</DelayBeforeSampling> [DelayBeforeSampling=]

<TransmitRealTime>no</TransmitRealTime> [MooredTxRealTime=]

</MooredMode>