EasyManua.ls Logo

Sea-Bird Electronics SBE 19plusV2 - Page 50

Sea-Bird Electronics SBE 19plusV2
268 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Section 4: Deploying and Operating SBE 19plus V2
40
Status Commands (continued)
GetEC Get and display event counter data, which
can help to identify root cause of a
malfunction. Event counter records
number of occurrences of common
timeouts, power-on resets, etc. Can be
cleared with ResetEC. Possible events that
may be logged include:
Power fail – main batteries and/or external
voltage below voltage cutoff
EEPROM read or EEPROM write – all
power removed (main batteries removed, and
back-up lithium batteries are dead)
Alarm short – woke up 19plus V2 to send a
command while logging in Moored mode
Alarm long –sent StartLater, but
StartDateTime= is more than 1 month in
future
AD7730 timeout – response from
temperature and pressure A/D converter
delayed; typically if woke up to send a
command while logging in Moored mode
AD7714 timeout – response from voltage
channel A/D converter delayed; typically if
woke up to send a command while logging
in Moored mode
FLASH out of memory – all available
memory space is used; autonomous sampling
continues, but no additional data written to
FLASH (does not overwrite)
FLASH correctable error – single bit error in
a page, corrects itself, does not affect data
FLASH ECC error – does not affect data
FLASH timeout – problem with FLASH
FLASH ready – problem with FLASH;
timeout error
FLASH erase failed – problem with FLASH
FLASH write failed – problem with FLASH
FLASH uncorrectable – problem with
FLASH; 2 or more bits of errors in a page
FLASH block overrun – problem with
FLASH
New bad block – problem with FLASH;
FLASH write or erase failed, or a FLASH
uncorrectable error
ResetEC Delete all events in event counter (number
of events displays in GetSD response, and
event details display in GetEC response).
Example: (user input in bold, command used to modify parameter in parentheses)
getec
<EventCounters DeviceType = 'SBE19plus' SerialNumber = '01906003'>
<EventSummary numEvents = '1'/> [can clear with ResetEC]
<Event type='alarm short' count='1'/>
</EventCounters>
47

Table of Contents