Seaga Quick Break Combo QB2000 - Page 53

53QB2000 9.2022 vers 1.0
8. TEST VEND
Thisfunctionteststhemotorononespeciedselection.
1. Press Service Mode Button
2. Press 8 for Selection motor test menu
3. Use number keys to enter selection to test and wait
4. Repeat for any other selections
5. Press * to exit to previous menu
9. SELECTION: ALL
This function tests all motors in sequence automatically. To stop the test, press * to exit.
NOTE: All selections should be empty prior to performing this test.
1. Press Service Mode Button
2. Press 9 for Selection motor test menu
3. Press * to exit to previous menu
10. TEST MODES
This menu contains diagnostic tests and settings for the following systems:
• Relays • System Logs*
• Vigilant Vend Sensor • On Door
• Drop Bias Setting* • Manual Defrost
TEST RELAYS
1. Press Service Mode Button
2. Press 0 for Test Modes
3. Press 1 to test relays
4. Press 1 to test Relay1
5. Press 1 to toggle relay ON/OFF
6. Press 2 to test Relay2
7. Press 2 to toggle relay ON/OFF
8. Repeat steps 6 and 7 for remaining relays 3 thru 6
9. Press * twice to exit to previous menu
OPTICS
Note: Not used on this model
LOG
Note: Do not use unless requested by trained personnel
1. Press Service Mode Button
2. Press 0 for Test Modes
3. Press 3 for Log
4.Usenumberkeystoenterpassword(2314)toviewlog