Attention
Please read this manual carefully before installation and operation. It is a detailed
introduction of configuration, design, specifications, installation, etc. of Sealand mass flow
meter.
The meter is produced according to National Regulation of Coriolis Mass Flow Meter
GB/T 31130-2014, approved & certified. Each sensor has its own paired transmitter.
Please do not change any component in case of failure.
Please cut off the power before installation. Keep junction box intact and wiring correct;
make sure no gasket, o-ring or holding screw missing, and electricity ex-proof device in
good condition during the installation.
To Next Page
Loading...