Doc. No.: A05280692 Rev. AE ECO: 13200 Date: 11/04/2019
NOTE: Throughout this manual the KinderGUARD® ID and KinderGuard SC- 40 ID Exit Panels
will be referred to as “ID Exit Panel”
Each ID Exit Panel and XIU can be powered by the wall mount local power supply . Cutband Receivers are
powered by an Electronic Security Devices STS-10CEELACI16CL central power supply on a
110/220/230VAC duplex outlet specific to regional or country options.
It is strongly recommended to run dedicated, isolated circuit to power exit panels and other devices.
NOTE: Do not extend the power supply cord provided. The maximum distance the
duplex outlet should be from the ID Exit Panel is ten cable feet.
NOTE: Do not connect to a receptacle controlled by a switch.
PLEASE READ SAFETY PRECAUTIONS IN SECTION 4 BEFORE PROCEEDING
SECTION 3 POWER AND GROUNDING REQUIREMENTS
To Next Page
