Doc. No.: A05280692 Rev. AE ECO: 13200 Date: 11/04/2019
PM Mode Feature
The PM Mode feature allows the user to select a single event, (one lock time and one unlock time) to automatically lock
and unlock the door system for everyday of the week. This will allow more control of unauthorized traffic through the
protected door during those times.
PM Mode Factory Default Disabled
To program the panel to arm and disarm at a selected time:
1. Enter *567 *987654321 and hold the one until one beep is heard
2. Enter current time of the day in military time
Two beeps=accepted
3. Enter unlock time in military time
Three beeps=accepted
4. Enter lock time in military time
Four beeps=accepted
To enable the PM mode feature
1. Enter *567 *987654321 and hold the one until one beep is heard
2. Enter 9999
Four beeps=accepted
To disable the PM mode
1. Enter *567 *987654321 and hold the one until one beep is heard
2. Enter 9009
One beep=accepted
The ID Exit Panel can be programmed to be armed 24 hours a day. Following the programming steps above, set
Current Time, PM Off Time, and PM On Time with the same time.
Example: Enter *567*987654321 and hold the one until one beep is heard
Current time = 0000
PM off time = 0000
PM on time = 0000
Then enter *567*987654321 hold the one until one beep is heard
Enter 9999 (One beep=accepted)
Display PM Times
1. Enter *567 *987654321 hold the one until one beep is heard
2. Enter 8888 Current time of the day while in PM will blink
3. Enter *567 *987654321 hold the one until one beep is heard
4. Enter 7777 PM off time will blink
5. Enter *567 *987654321 hold the one until one beep is heard
6. Enter 6666 PM on time will blink
APPENDIX E OLD PM PROGRAMMING
To Next Page
