Secutron MMX-2003-12NDS User Manual

MMX
TM
User Guide
29
Assisted Walk Test
Assisted Walk Test must be configured using the Configurator. When the Assisted Walk Test is configured, the
One Man Walk Test is replaced by the Assisted Walk Test. The Assisted Wall Test shall be in silent mode only.
To enter the Walk Test Menu, you must be in the Command Menu. To enter the Command Menu, press
when the display is in normal mode.
Step 1: Select the Walk Test Menu
1. Use and to scroll the cursor to “Walktest”.
2. Press to select the Walk Test Menu.
Step 2: Enter your passcode (if required)
Enter your passcode. See page 10 for instructions on
entering passcodes.
Step 3: Select the Assisted Walk Test option
1. Use and to scroll the cursor through the
menu.
2. Press to select the “Assisted” option.
Press to exit and return to the Command Menu.
Step 4: Select the Assisted Walk Test to see this next menu
1. Use and to scroll the cursor through the
menu.
2. Press to select an area for testing.
3. Start inspecting devices. All alarm and trouble events
shall be saved in the Walk Test log.
Press to exit and return to the Command Menu.
- Command Menu -
1 Reports
2 Bypass
3 Walktest
Enter passcode for
level 1 or higher:
- Walktest -
1 Assisted
2 Walktest report
- Walktest -
1st Floor
2nd Floor

Secutron MMX-2003-12NDS Specifications

General

Brand	Secutron
Model	MMX-2003-12NDS
Category	Control Panel
Language	English