Secutron MMX-2003-12NDS User Manual

Front Panel Menu Operation
38
8. Network Restart
Use the Network Restart after downloading the MMX
TM
configuration.
To select the Network Restart, you must be in the Comman Menu. To enter the Command Menu,
press when the display is in normal mode.
At this point the display will vary, depending on your choice:
• If you selected “no”, the display shows the message “Operation cancelled”, then it will return to the Command
Menu.
• If you selected “yes”, the system begins a reset and the display shows:
9. Configuration Info
Select this option if you would like to see the information regarding the configuration in the system.
The MMX
TM
display will show the following while in Configuration Info mode:
Step 1: Select Network Restart
1. Use and to scroll the cursor to “Network
Restart”.
2. Press to continue.
Step 2: Enter your passcode (if required)
Enter the passcode. See page 10 for instructions on
entering passcodes.
Default is Level 2 passcode required.
Step 3: Select “yes” or “no” to auto program
1. Use and to select “yes” or “no”.
2. Press to continue.
- Command Menu -
6 Clear Event Log
7 Clr Verif Count
8 Network Restart
Enter passcode for
level 2 or higher:
Are you sure you
want to reboot
whole network (all
nodes and CPUs)? Y
Initial system self
checks in process ...
Version 10.1.5
- Config Info -
Key ID:0xffffffff
ESD No: 0xffffffff
Tech No: 0xffffffff

Secutron MMX-2003-12NDS Specifications

General

Brand	Secutron
Model	MMX-2003-12NDS
Category	Control Panel
Language	English