Secutron MR-2605

Secutron Inc. 14
2.2 Optional Accessories
Model Number Name Description
MR-2605-R3 Relay module Provides 3 relays that are jumper programmable to
activate on common ‘alarm’, ‘supervisory’ or ‘trouble’.
Mounts inside the enclosure and plugs into the main
board.
MR-2806 Dual line dialer Communicates all alarms, supervisory and trouble
conditions to a Central Station using Contact ID, SIA or
10/20 BPS communication formats. Programmable using
the MR-2644 handheld programmer.
Mounts inside the enclosure and connects to the main
panel using a supplied 4-wire cable with connector.
MR-2644 Programmer Handheld programmer for the MR-2806 DACT.
MR-2605-T Remote trouble
indicator.
Single gang plate complete with common trouble buzzer,
trouble visual indicator, ‘AC on’ visual indicator and a
trouble silence / lamp test switch. Mounts remotely to a
single gang electrical box and is connected to the main
panel via the 4-wire ‘secur-bus’.
MR-2605-AT Remote trouble
indicator and alarm
indicator
Two gang plate complete with common trouble buzzer,
trouble visual indicator, ‘AC on’ visual indicator and a
trouble silence / lamp test switch and 5 red zone alarm
visual indicators and 5 yellow zone supervisory
indicators. Mounts to a standard 2 gang electrical box and
is connected to the panel via the 4-wire ‘secur-bus’.
MR-2605-SR EOL supervision relay Supervises the extended power wiring typically used for
installations that employ 4-wire smoke detectors. Mounts
in the field.
MRD-EOL4.7K EOLR End-of-Line resistor for NAC and Initiating circuits.
Mounts in the field.
MRD-MP400 EOLR plate Single gang plate with EOL resistor. Mounts to a single
gang electrical backbox.