Secutron MR-2605

Secutron Inc. iv
5 Panel Operation
5.1 Operating Sequences .................................................................................................... 33
5.2 General Zone Fire Alarms .............................................................................................. 33
5.3 Waterflow Alarms ........................................................................................................... 34
5.4 Supervisory Zone Alarms ............................................................................................... 34
5.4.1 Subsequent Fire Supervisory ......................................................................................... 34
5.4.2 Supervisory / Trouble Priority ......................................................................................... 34
5.4.3 Supervisory / Fire Alarm Priority .................................................................................... 34
5.5 Trouble Operation .......................................................................................................... 34
5.5.1 System Troubles ............................................................................................................ 35
5.6 System Reset Operation ................................................................................................ 36
5.7 Lamp Test ...................................................................................................................... 36
5.8 Walk Test (Installer function only) .................................................................................. 37
5.9 NAC operation ................................................................................................................ 38
5.9.1 Class ‘B’ operation selections: ....................................................................................... 38
5.9.2 Class ‘A’ operation selections ........................................................................................ 38
5.10 Relay Function ............................................................................................................... 38
5.10.1 Alarm Relay .................................................................................................................... 38
5.10.2 Trouble Relay ................................................................................................................. 38
5.10.3 Supervisory Relay (available with the MR-2605-R3 Relay Expander only) ................... 38
6 MR-2605 System Programming
6.1 Entering Installer Programming Mode ............................................................................ 40
6.1.1 Using the LED Indicators to Program the System .......................................................... 41
6.1.2 Using the Silence Trouble and Silence Alarm Controls to Program the System ............ 41
6.1.3 Using the Reset System and Lamp Test Controls ......................................................... 41
6.2 Programming and Exiting the System ............................................................................ 42
6.3 Programming Function Descriptions .............................................................................. 42
6.3.1 Zone Programming ........................................................................................................ 42
6.3.2 NAC Sounding Rate Programming ................................................................................ 44
6.3.3 NAC Automatic Signal Silence and NAC2 Strobe Mode Programming ......................... 45
6.3.4 Signal Silence Inhibit Timer and Walk Test Programming ............................................. 46
6.3.5 Waterflow Alarms Programming .................................................................................... 47
6.3.6 Reference AC Line Frequency (50 or 60 Hz) ................................................................. 48
6.3.7 Entering the Reset Programming Mode ......................................................................... 48
6.3.8 Removing a Module from the System ............................................................................ 49
6.3.9 Adding a Module to the System ..................................................................................... 49
6.3.10 Defaulting the System .................................................................................................... 50
6.4 Viewing the Event Buffer ................................................................................................ 51