ii
INTRODUCTION
BEFORE USING THE PRODUCT,
BE SURE TO READ THE FOLLOWING:
TO MAINTAIN SAFETY:
To ensure the safe operation of this product, be sure to read the following before usage:
The following instructions are intended for the users, operators and the personnel in charge of the operation of the
product. After carefully reading and suciently understanding the warning displays and cautions, handle the product
appropriately. Be sure to keep this manual close to the product or in a convenient place for future reference.
Herein, explanations which require special attention are enclosed with dual lines. Depending on
the potentially hazardous degrees, the terms of “
DANGER
”, “
WARNING
”, “
CAUTION
”, etc. are used.
Be sure to understand the contents of the displays before reading the text.
Indicates that mishandling the product by disregarding this pictograph will cause severe injury or
death.
Indicates that mishandling the product by disregarding this warning will cause a potentially
hazardous situation which can result in death or serious injury.
Indicates that mishandling the product by disregarding this caution will cause a slight hazardous
situation which can result in personal injury and/or material damage.
For the safe usage of the product, the following pictographs are used:
Indicates "
HANDLE WITH CARE
." In order to protect the human body and equipment, this display is attached
to places where the instruction manual should be referred to
Indicates a "
protective earth terminal
." Before operating the equipment, be sure to connect it to the ground (this
step may be omitted for products in which a power cable with earth is used)
• Perform work in accordance with the instructions herein stated:
Instructions for work are explained by paying attention to the aspect of accident prevention. Failing to perform work as
per the instructions can cause accidents. In the case where only those who have technical expertise should perform
the work to avoid hazardous situation, the instructions herein state that the site maintenance personnel should
perform such work
• Besuretoturnothepowerbeforeworkingonthemachine:
To prevent an electric shock, be sure to turn o the power and unplug the power cable before carrying out any work
that requires direct contact with the interior of the product. If the work is to be performed in the power-on status, the
instruction manual herein always states to that eect
• Be sureto ground the earthterminal (not requiredin the casewhere a powercable with earthis used):
This product is equipped with the earth terminal. When installing the product, connect the earth terminal to the
"accurately grounded indoor earth terminal" by using an earth wire. Unless the product is grounded appropriately, the
user can be subject to an electric shock. After performing repair, etc. for the control equipment, ensure that the earth
wire is rmly connected to the control equipment
• Ensurethatthepowersupplyusedisequippedwithanearthleakagebreaker:
Using a power supply which is not equipped with the earth leakage breaker can cause a re when earth leakage
occurs
• Besuretousefuseswhichmeetthespeciedrating(onlyforthemachineswhichusefuses):
Using fuses that exceed the specied rating can cause a re and an electric shock
PICTOGRAPHS AND DEFINITIONS