INTRODUCTION
iii
• Specicationchanges(removal ofequipment,conversions andadditions)not designatedby SEGAare not
allowed:
The parts of the product include warning labels for safety, covers for personal protection, etc. It is very hazardous
to operate the product by removing parts and/or modifying the circuits. Should doors, lids and protective parts be
damaged or lost, refrain from operating the product, and contact where the product was purchased from or the oce
herein stated.
SEGA shall not be held responsible for any accidents or compensation for damage to a third party resulting from the
specications not designated by SEGA
• Ensurethattheproductmeetstherequirementsofappropriateelectricalspecications:
Before installing the product, check for electrical specifications. SEGA products have a nameplate on which the
electrical specifications are described. Ensure that the product is compatible with the power supply voltage and
frequency requirements of the location. Using any electrical specications dierent from the designated specications
can cause a re and an electric shock
• Installandoperatetheproductinplaceswhereappropriatelightingisavailable,allowingwarninglabelsto
beclearlyread:
To ensure safety for the customers, labels and printed instructions describing potentially hazardous situations are
applied to places where accidents can be caused. Ensure that where the product is operated has sucient lighting
allowing the warnings to be read. If any label is peeled o, apply it again immediately. Please place an order with
where the product was purchased from or the oce herein stated
• Whenhandlingthemonitor,takeconsiderablecare(appliesonlytoproductswithmonitors):
Some of the monitor parts are subject to high tension voltage. Even after turning o the power, some portions are
still subject to high tension voltage. Monitor repair and replacement should be performed only by those technical
personnel who have knowledge of electricity and technical expertise
• Besuretoadjustthemonitorproperly(appliesonlytoproductswithmonitors):
Do not operate the product leaving on-screen ickering or blurring as it is. Using the product with the monitor not
properly adjusted may cause dizziness or a headache to an operator, a player, or customer
• Whentransportingorresellingthisproduct,besuretoattachthismanualtotheproduct
* In the case where commercially available monitors and printers are used in this product, only the contents relating to
this product are explained herein. Some commercially available equipment has functions and reactions not stated in
this Manual. Read this Manual together with the specic instruction manual of such equipment
* Descriptions herein contained may be subject to improvement changes without notice
* The contents described herein are fully prepared with due care. However, should any question arise or errors be
found, please contact SEGA
INSPECTIONS IMMEDIATELY AFTER TRANSPORTING THE PRODUCT TO THE LOCATION
Normally, at the time of shipment, SEGA products are in a status allowing for usage immediately after transporting to the
location. Nevertheless, an irregular situation may occur during transportation. Before turning on the power, check the
following points to ensure that the product has been transported in a satisfactory status:
Are there any dented portions or defects (cuts, etc.) on the external surfaces of the cabinet?
Are castors and adjusters damaged?
Do the power supply voltage and frequency requirements meet with those of the location?
Are all wiring connectors correctly and securely connected? Unless connected in the correct way, connector
connections can not be made accurately. Do not insert connectors forcibly.
Do power cables have cuts or dents?
Are all accessories available?
Can all doors and lids be opened with the accessory keys? Can doors and lids be rmly closed?
To Next Page
Loading...
Need help?
General
