Sega Snakes & Ladders - Controller Unit(s); Controller Maintenance & Adjustment

CONTROL UNIT
44 45
CONTROL UNIT
10 10
• Whenworkingwiththeproduct,besuretoturnthepoweroff.Workingwiththe
poweronmaycauseanelectricshockorshortcircuit.
• Becarefulnottodamagethewires.Damagedwiresmaycauseanelectric
shock,shortcircuitorpresentariskofre.
• Exerciseduecautioninperformingsolderingwork.Ifsolderingironishandled
carelessly,therecouldberesorburns.
• Whenfasteningplasticparts,becarefulnottotightenscrewsornutsexcessively.
Ifthesearetightenedtoexcess,partscouldbedamaged,resultingininjuries
fromfragments,etc.
• Aftertheunithasbeendisassembledandreassembledagain,checkcarefully
thattheunithasbeenreassembledcorrectly.
• Besuretoinspecttheouterelementsonbothcontrollerunits.
• Ressemblesothatthereisnogapbetweenplatesandcovers.Ifthereisagap
orrattling,theplayerscouldgetngersorhandscaught,resultingininjury.
• Becarefulnottodamageorlosesmallpartsorscrews.
• Whenaparthasbeenreplaced,besuretoalwaysmakeadjustmentsand
checkconditionsinTestMode.
10 CONTROLLER UNIT(S)
10-1 AJUSTING/CHANGING THE POT
Besuretoremovethepowerbeforeattemptingserviceorrepairtothecontroller.
Failuretoremovepowermayresultincomponentdamageorshockhazzard.
In cases where the Handle operability is poor and/or the adjustment or replacement of the POT is required. It may be
nescessary to replace either the COIL or the POT from within the controller depending on the fault condition.
In game, when the handle is pulled fully along its path the gage around the outside of the upper disc should indicate
a MAX spin. If this is not the case then it is possile that the POT within the controler may need to be adjusted or re-
placed. Carefully follow the instructions below to carry out this operation.
An adjutable wrench is required for the following procedure.
1
Turn off the power.
2
Using the key - open the Console lid to access either left or right controllers.
3
Locate the machanics of the controller. Take care when working in this area. DO NOT pull on the handle
when working on the controller. Keep ngers away from moving parts at all times.
Controller mechanics
Unlock and open console door