13
LAMPS AND LIGHTING
LAMPS AND LIGHTING
13
66 67
3
The 5 digit LED Board is located at the top of the cabinet. To remove the LED board simply press the locating
pins on each of the 4 PCB mounts to release. Disconnect harness at rear of PCB and remove.
4
Replace the 5 Digit LED board and reassemble by following these instructions in revers order.
5 Digit LEd Display
PCB mount
13-4 REPLACING THE LED (WHT) SNAKE BODY
1
Locate the Snake Body segment to which the LEDs are to be replaced.
2
Remove the (5) M4 xings from around the outer edge of the segment.
3
Carefully slide off the acrylic shell to reveal the LED strips.
To Next Page
Loading...
