Sega Snakes & Ladders - Replacing the Led (Wht) Feature Reel; Tracker

13
LAMPS AND LIGHTING
LAMPS AND LIGHTING
13
68 69
4
Each of the (5) LED strips are adhered to the back of the Snake Body. Disconnect the harness to the LED
strip to be removed and carefully peel away the LED strip from the board.
5
Peel the backing away from the NEW LED strip to be added and offer up to Snake Body. Adhere into
position pressing rmly along the strip to complete adhesion.
6
To
ret the Snake Body Cover and secure into place - follow these instrucions in reverse order.
LED Strips
Reconnect connector
13-5 REPLACING THE LED (WHT) FEATURE REEL / TRACKER
1
REMOVE POWER from the cabinet and diconnect the POWER LEAD.
2
Follow steps 1 through to 8 on Chapet 11 section 1 of this manual to remove Tracker Unit and Feature Band.
3
Remove the Feature band to reveal the individual LED Strips.
LED Strips
Tracker Unit
The LED Strips behind the Feature or Tracker Band are soldered in its connection
to the harness, Take care when using appliances such as soldering/desoldering
equipment. Only qualied personel should carry out such tasks.
TAKE CARE WHEN ACCESSING THE INTEGRAL PARTS OF THE MACHINE.
MAKE SURE POWER IS REMOVED BEFORE SERVICING.
ONLY TOUCH PARTS WHICH ARE OUTLINED IN THE INSTRUCTIONS BELOW. FAILURE
TO OBSERVE THIS CAUTION MAY RESULT IN INJURY OR COMPONENT DAMAGE.