13
LAMPS AND LIGHTING
LAMPS AND LIGHTING
13
64 65
3
The LED strips are adhered to the ladder board using a purpose adhesive strip. Identify the LED strip which
is to be changed, disconnect it and carefully peel it away from the Ladder Board.
4
Apply the NEW LED strip by peeling away the protective backing and carefully placing it in to position.
Press rmly along the length of the strip between each LED segment taking care not to apply to much
pressure. Reconnect the LED harness.
5
Follow step 2 in reverse to re attach the Ladder Artwork Panel taking care not to overtighten the xings.
Locate LED strip to be
replaced.
Hole
Disconnect connector at
rear of board
Reconnect connect the
harness at rear of board
Peel away the protective
backing tape
Apply the new LED strip into
loaction and feeed the harness
through the hole in the ladder
board
Carefully peel away
LED strip
13-3 REPLACING THE 5 DIGIT NUMERIC DISPLAY
TAKE CARE WHEN ACCESSING THE INTEGRAL PARTS OF THE MACHINE.
MAKE SURE POWER IS REMOVED BEFORE SERVICING.
ONLY TOUCH PARTS WHICH ARE OUTLINED IN THE INSTRUCTIONS BELOW. FAILURE
TO OBSERVE THIS CAUTION MAY RESULT IN INJURY OR COMPONENT DAMAGE.
REMOVING THE WHT LED ARRAY
1
REMOVE THE POWER and DISCONNET THE POWER CABLE
2
Follow instruction 2 from the previous step to remove the Ladder Artwork Panel.
Remove Ladder Artwork Panel using instructions from previous step.
5 Digit Numeric Display.
To Next Page
Loading...
