SEH PS Series - Page 129

Maintenance
Print Server User Manual Windows 124
Resetting Parameters via the Print Server Homepage
Proceed as follows:
1. Start the Print Server Homepage.
2. Select Actions – Default Settings.
3. Click Default settings.
 The parameters are reset.
Resetting Parameters via the InterCon-NetTool
Requirements
 The InterCon-NetTool is installed on the client, see: 15.
Proceed as follows:
1. Start the InterCon-NetTool.
2. Select the print server from the device list.
3. Select Actions – Default Settings from the menu bar.
4. Click Finish.
 The parameters are reset.
Resetting Parameters via an FTP Connection
Proceed as follows:
1. Open an FTP connection to the print server:
Syntax: ftp <IP address>
Example: ftp 192.168.0.123
2. Enter either the print server password or press the enter key if
no password has been assigned.
3. Reset the parameters:
quote SITE RESET
4. Close the FTP connection:
quit
5. Interrupt the power supply of the print server. To do this,
disconnect the power supply from the print server and then
reconnect it.
 The parameters are reset.