SEH PS Series - How to Define a Password for the Print Server (Read;Write Protection)

Security
Print Server User Manual Windows 88
10.1 How to Define a Password for the Print Server
(Read/Write Protection)
Write Protection
A password can protect the print server against unauthorized
parameter modifications. If a password was set, you must enter the
password before you can save the changes to the parameters. This
means that changes to the parameters can only be made using a
valid password.
Read protection
In addition, you can protect the display of parameters with a pass-
word too. For this purpose, the parameter Access control must be
enabled. If this parameter is enabled, a password must be entered
when opening ther Print Server Homepage or the Properties dialog
via the InterCon-NetTool.
What do you want
to do?
 ’Defining the Password via the Print Server Homepage’ 88
 ’Defining a Timeout via the InterCon-NetTool’ 88
Defining the Password via the Print Server Homepage
Proceed as follows:
1. Start the Print Server Homepage.
2. Select Configuration - Protection.
3. Enter a password into the Password box in order to enable the
write protection.
4. Tick Access control in order to define the read protection, if
required.
5. Click Save to confirm.
 The settings are saved.
Defining a Timeout via the InterCon-NetTool
Requirements
 The InterCon-NetTool is installed on the client, see: 15.
Proceed as follows:
1. Start the InterCon-NetTool.