SEH PS Series - How to Use ThinPrint AutoConnect

Additional Feature – ThinPrint®
Print Server User Manual Windows 138
4. Enter the desired bandwidth (bit/s).
5. Click Save to confirm.
 The setting will be saved.
Configuring the Bandwidth via InterCon-NetTool
Requirements
 The InterCon-NetTool is installed on the client, see: 15.
Proceed as follows:
1. Start the InterCon-NetTool.
2. Double-click the print server in the device list.
The Properties dialog appears.
3. Select Configuration – ThinPrint®.
4. Tick Bandwidth.
5. Enter the desired bandwidth (bit/s).
6. Click OK to confirm.
 The setting will be saved.
14.4 How to Use ThinPrint AutoConnect
ThinPrint AutoConnect is a tool within the ThinPrint technology for
the automatic creation of print objects. The printer objects are cre-
ated on the basis of defined templates without the need to auto-
matically load the printer drivers.
Printers can be combined in printer groups and printer locations on
the basis of so-called printer classes. A name table translation
(Dynamic Printer Matrix) simplifies the creation of classes and the
assignment of printers.
In the case of several drivers we recommend the assignment of the
appropriate printer drivers via the printer class. This assignment can
be set up accordingly in the printer configuration on the ThinPrint
client.
What do you want
to do?
 ’Configuring AutoConnect via Print Server Homepage’ 139
 ’Configuring AutoConnect via InterCon-NetTool’ 139