SEH PS Series - Page 70

Print Server Status Information
Print Server User Manual Windows 65
Defining the Data Format via the Print Server Homepage
Proceed as follows:
1. Start the Print Server Homepage.
2. Select Configuration – General.
3. Select the desired data format from the Status page mode list.
4. Click Save to confirm.
 The setting will be saved.
Defining a Data Format via the InterCon-NetTool
Requirements
 The InterCon-NetTool is installed on the client, see: 15.
Proceed as follows:
1. Start the InterCon-NetTool.
2. Double-click the print server in the device list.
The Properties dialog appears.
3. Select Configuration – General.
4. Select the desired data format from the Status page mode list.
5. Click OK to confirm.
 The setting will be saved.
Defining a Data Format via the InterCon-NetTool
Requirements
 The InterCon-NetTool is installed on the client, see: 15.
Proceed as follows:
1. Start the InterCon-NetTool.
2. Select the print server from the device list.
3. Select Actions – Print Status Page from the menu bar.
4. (Depending on the print server model, you may be asked to
specify the printer port. Select the printer port and confirm by
clicking Next.)
5. Click Finish.
 The status page is printed.