Sena SRL2 User Manual

SRL2
51
English
24 FAULT RESET
When the SRL2 is not working properly or is in faulty status for any
reason, you may reset by pushing the pin-hole reset button located
next to the DC Power Charging & Firmware Upgrade Port. Insert a
paper clip into the reset pin-hole and press the reset button for a
second with light pressure. The SRL2 will be switched off, and you
have to turn on the system back on and try again. However, this will not
restore the headset to factory default settings.
1
2
Note:
The charging LED is not a pin-hole reset button. Do not press it.
Charging LED

Sena SRL2 Specifications

General

Bluetooth Version	Bluetooth 4.1
Talk Time	10 hours
Charging Time	2.5 hours
FM Radio	Yes
Battery Type	Lithium Polymer Battery
Certificates	CE, FCC, IC
Music Sharing	Yes
Voice Command	Yes
Intercom Range	1.6 km (1.0 mile)
Operating Temperature	-10°C to 55°C (14°F to 131°F)
Profiles	Headset Profile (HSP), Hands-Free Profile (HFP), Advanced Audio Distribution Profile (A2DP), Audio Video Remote Control Profile (AVRCP)
Audio Features	Advanced Noise Control™
Compatibility	Shoei GT-Air II, Shoei Neotec II, Shoei J-Cruise II
Mobile App Support	Yes
Intercom Participants	8-Way Intercom