Sensaphone 400 - Page 42

40
SENSAPHONE 400 User’s Manual
To program the ID Message:
1. Press the SET key.
SET
2. Press the MESSAGE key. The 400 will say “Enter Message Number.”
MESSAGE
3. Press the ID key (number 0 key).
0
ID NUMBER
POWER
4. When the unit beeps, begin speaking your message into the microphone.
The unit will say “OK,” when the recording time has elapsed; then it will
play back your recorded message.
To play back the ID Message:
1. Press the WHAT IS key.
WHAT
IS
2. Press the MESSAGE key.
MESSAGE
3. Press the ID key (number 0 key).
0
ID NUMBER
POWER
The 400 will play back your recorded message.
The Zone Messages are used to identify the device or condition being mon-
itored such as temperature, humidity, equipment alarms, security alarms,
etc.
To program the Voice Message for a Zone:
1. Press the SET key.
SET