Sensaphone 400 - Obtaining Current Temperature; Ac Power Monitoring Enable;Disable; Enabling;Disabling the AC Power Alarm

Chapter 5: Alarm Programming
77
3. Press the number key corresponding to the selected temperature zone.
4
MAX CALLS
3
INTERCALL
TIME
1
CALL
DELAY
2
VOICE
REPS
5.7 obtaInIng Current temperature
Current temperature readings for each temperature zone may be accessed
at any time. The Model 400 recites the zone number, and the actual tem-
perature detected by the attached sensor, for all zones configured as tem-
perature. To obtain current temperature:
1. Press WHAT IS.
WHAT
IS
2. Press TEST °F/°C.
TEST
°F/°C
#
5.8 aC power monItorIng enable/dISable
The Model 400 monitors AC power failure. This command enables or dis-
ables the power failure detection feature.When enabled, the Model 400 will
monitor power and dial out when AC power failure exceeds a programma-
ble span of time (refer to AC Power Failure Recognition Time, Section 5.9).
The default setting for AC power monitoring is enabled (on). When dis-
abled, the Model 400 will not dial-out to report power failure.
5.8.1 enablIng/dISablIng the aC power alarm
1. Press SENSOR ON/OFF.
SENSOR
ON/OFF
2. Press POWER.
0
ID NUMBER
POWER
• The Model 400 will say “Power Alarm Disabled” to indicate that the
power alarm is disabled, or
• The Model 400 will say “Power Alarm Enabled” to indicate that the power
alarm is enabled.
3. Repeat key sequence to change settings.