52
SENSAPHONE 400 User’s Manual
4.6.4 SpeCIal dIalIng to a beeper or pager
Your Sensaphone can be programmed to send an alarm message to a
numeric beeper/pager. The message will include the Sensaphone’s tele-
phone number (ID number) and the Zone numbers that are in alarm. For
example, if zones 1 and 4 are in alarm, the message on your pager would
be: 8882227777-1-4, where 8882227777 is the unit’s ID number. A Sound
alarm will appear as alarm -9 and a Power alarm will appear as alarm -0.
To program a telephone number for Pager dialout, you must enter Code 1
at the beginning of the telephone number. The Sensaphone will say “Code
one, Pager” when you enter the command.
Follow the key sequence below to dial a numeric pager:
SET + PHONE NUMBER + any unassigned number key 1-4 +
CODE + 1 + pager telephone number + ENTER
To check your programming:
WHAT IS + PHONE NUMBER + assigned # 1-4
The Sensaphone will say “Pager”, followed by the programmed telephone
number.
To send a test page:
SET + TEST + assigned # key 1-4 + ENTER
The Sensaphone will let you listen to the dialout sequence through its
speaker and send you a message that includes the Sensaphone’s telephone
number (ID number).
Voice Prompted Paging Systems
If your paging provider is answered by a voice prompt which requires you
to enter one or more touch-tones to send a message, then use the wait-for-
answer code (4.5.1) in combination with the Pause key and other number
keys to navigate the voice menu until you reach the message entry point.
The Sensaphone will automatically send it’s telephone number, Zone num-
bers, and a pound (#) tone at the end of the number. For assistance contact
Sensaphone Technical Support at 1(877)373-2700.
To Next Page
Loading...