Sensaphone 400 - Exit Delay

Chapter 5: Alarm Programming
83
9
LISTEN TIME
SOUND
3. Repeat key sequence to change settings.
5.12 exIt delay
When tripping an alarm is unavoidable, yet a true alert condition has not
actually occurred, the alarm response, including dial-out, can be temporar-
ily suppressed.
The Model 400 is able to suppress and then reset its dial-out function auto-
matically through use of the Status Report. This is especially convenient
when an alert condition is created upon exiting a monitored door, and
there is no way to cancel from the local keypad.
Example: You are planning to exit through a monitored door. Prior to
exiting, you initiate a Status Report recitation at the Model 400 keypad
by pressing WHAT IS, followed by STATUS, (key sequence shown
below). This allows you approximately 40 seconds to exit without
activating the Model 400’s programmed response to an alarm. At the
conclusion of the status report, normal alarm response is reactivated.
To use exit delay, initiate the Status Report.
1. Press WHAT IS.
WHAT
IS
2. Press STATUS. The Model 400 recites the full Status Report; during this
time, you are able to exit the monitored area without tripping an alarm.
STATUS