Chapter 4: Communications Programming
47
3. Press 0 then ENTER to enter manual dialing mode. The 400 will go
off-hook and you should hear a dial tone through the speaker. Press any
number keys to dial a telephone number.
0
ID NUMBER
POWER
4. Press ALARM CANCEL to hang up and exit the test.
ALARM
CANCEL
4.5 tone or pulSe dIalIng
The Model 400 can dial out in pulse or Touch Tone™. Select the type of
dialing, in either pulse or tone, depending upon the type of service pro-
vided by your telephone company. The default is tone.
To program for either pulse or tone:
1. Press the SENSOR ON/OFF key.
SENSOR
ON/OFF
2. Press PHONE NUMBER T/P.
PHONE
NUMBER
T/P
The Model 400 will respond: “Tone” to indicate that tone dialing is enabled,
or “Pulse” to indicate that pulse dialing is on and enabled.
3. Repeat key sequence to switch between settings.
4.6 SpeCIal dIalIng
The Model 400 has provisions for special dialing sequences. Special dialing
sequences allow:
• Dialing that requires an access number to connect with an outside line.
• Dialing that requires the pound (#) or star (*).
• Dialing to a beeper or pager.
To Next Page
Loading...