Sensaphone 400 - Designating a Zone as Unused

84
SENSAPHONE 400 User’s Manual
5.13 deSIgnatIng a Zone aS unuSed
This feature allows you to mark selected Zones, Power, or Sound as unused,
which will prohibit them from going into alarm and will also leave them
out of the status report. Note that programming for the selected Zone will
be preserved when the Zone is marked as “unusued” and will not be recon-
figured if automatic Zone configuration is activated.
To designate a Zone as unused:
1. Press the SENSOR ON/OFF key.
SENSOR
ON/OFF
2. Press the SET key.
SET
The 400 will say “Enter Zone Number.”
3. Press the corresponding number of the Zone you wish to mark as
unused.
4
MAX CALLS
5
TEMP LIMITS
6
CALIBRATE
8
CLOCK
3
INTERCALL
TIME
7
RECOGNITION
TIME
9
LISTEN TIME
SOUND
0
ID NUMBER
POWER
1
CALL
DELAY
2
VOICE
REPS
The 400 will respond by saying Zone 1–4, Power, or Sound “Off/On.”
Repeat the key sequence to place the Zone back in use.