Sensaphone 400 - Dial-Out Test Mode; To Test a Dialout Phone Number; Manually Dial a Telephone Number

46
SENSAPHONE 400 User’s Manual
4.4 dIal-out teSt mode
The 400 allows you to test your telephone programming by simulating an
alarm dialout to any programmed telephone number. This can be a valu-
able tool for insuring that your programming is correct and also for trou-
bleshooting dialing problems. In this mode all signals on the telephone line
are audible through the local speaker.
4.4.1 to teSt a dIalout phone number:
1. Press the SET key.
SET
2. Press the TEST key.
TEST
°F/°C
#
The 400 will say “Enter Number.”
3. Press a number key (1–4) corresponding to the phone number entry you
wish to test, and press ENTER.
4
MAX CALLS
3
INTERCALL
TIME
1
CALL
DELAY
2
VOICE
REPS
ENTER
PM
The 400 will dial the number and announce the date and time for voice
calls, or send its ID number for pager calls.
4.4.2 manually dIal a telephone number
1. Press the SET key.
SET
2. Press the TEST key.
TEST
°F/°C
#
The 400 will say “Enter number.”