88
SENSAPHONE 400 User’s Manual
6.2.1 example: StatuS report, no alarmS
Zones 2, 3, and 4 are configured as dry contact and zone 1 is configured as
temperature. No alarms exist. The Status Report begins by saying, “Hello,
this is 555-1234, this is building M, third floor; it is now 2:30 pm.”
Following this introduction, the report continues:
“Zone 1, room temperature, 74 degrees, OK.”
“Zone 2, door alarm, OK.”
“Zone 3, ups alarm, OK.”
“Zone 4, water sensor, OK.”
“The sound is OK.”
“The power is ON.” This refers to AC power.
“The batteries are OK.” Other possible responses: “Batteries are low” or
“Replace batteries.” (Refer to Section 6.2.4 for additional information
regarding battery condition.)
“The output is off.”
“Listen to the sound for 10 seconds.” In this case, the programmed Listen-in
Time is set at 10 seconds. (This feature is not available when obtaining the
Status Report on-site, directly at the keypad.)
The Status Report repeats once more and the Model 400 concludes the call,
saying: “Goodbye.” (The Status Report will not repeat if obtained at the key-
pad; “Goodbye,” is also not recited.)
The phrase “no number” at the end of a Status Report indicates that no dial-
out phone numbers have been programmed.
6.2.2 example: StatuS report, exIStIng alarmS
Zones 2, 3, and 4 are configured as dry contact and zone 1 is configured as
temperature. An emergency situation is at hand: a fire in a greenhouse has
tripped a smoke alarm and electrical power has been disrupted. In addi-
tion to high sound and AC power alarms, separate alarms exist on zones 1,
2, 3, and 4. You happen to call in for the Status Report, which begins with,
“Hello, this is 555-1234; “this is the Sensaphone 400 at ACME Greenhouse,
225 Oak Street”
It is now 8:45 PM
Zone 1, “Temperature in greenhouse”, 110 degrees Fahrenheit, too high,
acknowledged alarm exists
Zone 2, “Door alarm in greenhouse”, not OK, acknowledged alarm exists
To Next Page
Loading...