Io
SENSOR
Section 4 RF/ID Tag Reader
SMT-200 Operations and Technical Manual 2.00/R1
57
4.5 Settings
4.5.1 COM settings
When using the Tag reader the SMT-200 baud rate can be set in the menu SMT-200, COM settings.
The tag reader baud rate must be set to 9600 baud.
4.5.2 Autonumber
When the Autonumber option is ON and you are testing a ‘new’ tag, the SMT-200 assigns a string
number and starts testing immediately.
If you want to enter in the string number manually the Autonumber setting should be set to OFF.
4.5.3 Tag menu visible
In the menu SMT-200, Operating there is a checkbox Tag menu under the System label. Use this
option to enable the tag menu in the SMT-200.
To Next Page
Loading...