Table of contents Io
SENSOR
vi
SMT-200 Operations and Technical Manual 2.00/R1
Table of Contents
Page
SECTION 1 INTRODUCTION 1
1.1
Introduction 3
1.2
Technical Support 3
1.3
Overview 4
1.4
Specifications 4
1.5
Packaging information 5
1.6
Before use... 6
1.6.1
Voltage selection 6
1.6.2
Battery charging 6
SECTION 2 SMT-200 OPERATIONS 7
2.1
SMT-200 Layout 9
2.2
Switching on the SMT-200 9
2.2.1
Post Mortem on Powering up 10
2.3
Navigating around the screens 10
2.4
Switching off the SMT-200 13
2.5
Battery level 14
2.6
Battery level Jumper setting 15
2.7
Menu flowchart 16
2.8
Main menu The main menu allows access to all functions of the SMT-200 19
2.9.1
Do a test Select this option to initiate a test sequence on a string 19
2.10.2
Setup menu Allows customisation of the SMT-200 operating and test parameters 20
2.11.2.1
String menu Set the string geometry and leader parameters 20
2.12.2.1.9
Limits menu Sets maximum allowable limits for various tests 21
2.13.2.2
Geophone menu Selects and modifies if required the type of geophone element used 21
2.14.2.2.1
Select menu Selects the type of geophone element used 22
2.15.2.2.2
Edit Edit the geophone parameters 22
2.16.2.2.3
Copy Copy existing element description to a new geophone type 22
2.16.2.2.4
Delete Deletes an existing element description 22
2.17.2.3
Operating menu General options for string testing 23
2.18.2.4
Tests Sequence Selects the tests to be performed on the string 24
2.19.2.5
Display menu Customises display, keypad and sound options 24
2.20.2.7
Power menu Selects the various power saving options 25
2.21.2.8
Date & Time Sets the SMT-200 clock 25
2.22.2.9
Diagnostics Runs the diagnostics and calibration routines 26
2.23.3
Temp. menu Read or set the external temperature and temperature options 28
2.24.4
File menu Internal file handling and data / code transfer options 30
2.25.4.1
Redisplay Last Shows the result of the last test run 30
2.26.4.2
Storage Status Indicates the internal memory storage 31
2.27.4.3
Dump data file Transfer contents of data file to COM port 31
2.28.4.4
List data file List contents of data file 32
2.29.4.5
Erase data Clears contents of data file 32
2.30.4.6
Read Config Loads the stored configuration file 33
2.31.4.7
Save Config Saves the configuration file 33
2.32.6
About Provides general information about the SMT-200 34
To Next Page
Loading...