Sensus AR5000 User Manual

Sensus AR5000 User’s Guide 2-17
Enter Data
To enter a TouchRead...
1 Use the TAB key to scroll through the route, to the location
where you want to enter information.
The system displays “Perform TouchRead” across the top
of the screen for addresses that are setup for
TouchReadings.
2 Place the flat disk face of the reading gun against the
TouchPad remote or pit-lid mounted TouchPad (TR/PL)
module and squeeze the trigger.
How To Hold the GunThe system briefly displays a “Receiving Readings”
message, while receiving data.
• If the reading is successful, the system sounds a beep
and stores the reading.
Error Reading Device Message• If the system is unable to read the information, the
screen displays an “Error Reading Device” error
message. For more information, see
Resolve Reading
Malfunctions and Bad Reads
on page 2-12.
• If the meter ID does not match the information for that
address on the route, the system initiates an
“Address/Meter Mismatch” error. For more information,
see
Resolve Readings That Don’t Match the Displayed
Location
on page 2-9.
• If the meter ID does not match any ID on the route, the
system initiates a “Non-Route Meter” error. For more
information, see
Resolve a Non-Route Meter on
page 2-10.
Note You can attempt a TouchRead on any meter
equipped with an encoder, regardless of the
information on the AR5000 display.

Sensus AR5000 Specifications

General

Brand	Sensus
Model	AR5000
Category	Data Loggers
Language	English