2–20 Sensus Metering Systems
Chapter 2: Collect Meter Data
The note can be any length, up to 50 characters.
When you are finished, use the TAB key to select
OK
and press the ENTER key.
Note List Screen  Use the TAB key to select
Note List
.
Press the ENTER key. The system displays a list of
preset notes. Use the PgUp and PgDn keys to highlight
a note from the list. Press the ENTER key to select the
note.
 Mark Locations
Typical Marked Address You can place a mark on any location in the route. This mark
is typically used along with notes, for reviewing information
after a route is complete. For example, you may have an
issue with a meter, mark it, and return at the end of the route
to attempt to resolve the issue.
You can search for marked addresses at any time. For more
on locating marks, see
Find Marked Locations
on page 3-17.
To Mark/Unmark an address...
1 To mark an address, complete the following steps:
a Use the TAB key to scroll through the route to the
location you want to mark/unmark.
b Use the F4 key to mark the address.
Note
You can exit the Enter Text screen by pressing
the Esc key, or use the TAB key to select
Cancel and press the ENTER key.
To Next Page
Loading...
Need help?
General
