+49 33631 59 650
info@sensys.de
www.sensys.de
Manual
SBL10
8 / 69
Version 1.27
Advice for Devices with Battery Supply or
Accumulator
2.2
Batteries or accumulators may explode when used inappropriately.
Please pay attention to the following instructions:
• use only batteries or accumulators that were specified by the producer for this device
• take care of the correct polarity when inserting batteries or the accumulators
• never expose batteries or accumulators to high temperatures or fire
• keep the battery terminal dry and keep it away from contact with conductive materials
Please pay attention to the following safety instructions in order to prevent damages on
the device:
After using the device or in case of disuse for a longer period of time, please remove the batteries
or the accumulators.
Damages caused by the inappropriate use of the accumulators (short-circuit, drain, mechanical
damages) and consequential loss cannot be claimed as guarantee.
The disposal of the accumulators and batteries should only take place in the collecting
basins or points designed for this purpose.
Cleaning Advice2.3
Please use a moist and soft cloth for cleaning the device.
The contact of water with the electronic circuitry and with the contacts of the plugs and the plug
sockets has to be avoided. Damaged cables and plugs as well as casings of the sensor should not
be cleaned with water.
Don’t clean the device with chemical substances or with mechanical additives. This may
cause damages of the components!
After cleaning the device respectively the single components, please put them into the provided
case for transport. If the interior of the case got wet, please dry it before using it again.
To Next Page
Loading...
Need help?
General