Installation
2.1 Preparation for use
To use the FastTracer simply position the sensor correctly and start up FTAnalyzer or Esplora 3D.
This chapter describes the various aspects concerning the software installation and the correct
sensor positioning and fastening.
2.2 System requirements
FastTracer works on normal desktop or laptop computers with Windows 2000, XP, Vista and
Windows 7 and requires the following hardware:
Minimum Standard Suggested
Processor X86 – 500 MHz X86 – 900 MHz X86 – 1.6 MHz
RAM 128 MB 512 MB 1 GB
Hard Disk available
space
20 MB 1 GB 5 GB
Video SVGA SVGA SVGA
Ports USB 2.0 USB 2.0 USB 2.0
Other Mouse – CD Rom Mouse – CD Rom Mouse – CD Rom
Microsoft Office
compatibility
Office 2000 or sub. Office 2000 or sub. Office 2000 or sub.
System requirements
2.3 FTAnalyzer installation
Before installation, all programs in execution
on the computer should be shut down. It is
recommended not to connect the
measurement device until the software
installation procedure is complete.
2
To Next Page
Loading...