3.4.3 Menu
The menu toolbar (FTAnalyzer) consists of four pop-up menus which allow the user to carry out
different actions. The table below shows the different menus with a general description.
3.4.4 Global settings
To display settings (FTAnalyzer), proceed through the menu as follows:
View>Global Settings
in this view you can change different FTAnalyzer parameters.
To exit the program
To carry out measurements (see paragraph 3.5)
To load a file as file device
To display the device list
To display FTAnalyzer settings
To display the toolbar
Full-screen application
To start FTEditor
To restore toolbar default conditions
To display the Graphics area for the data overview
To recall the stored view configuration
To save the view configuration
Information about FTAnalyzer
To Next Page
Loading...