Sequoia LISST-200X User Manual

LISST-200X User’s Manual LISST-200X Operation Details Page 83
The stop condition options are:
1 = Depth Stop
2 = Time/Date Stop
3 = Mechanical Switch Stop
4 = Digital Input Stop
5 = Number of Samples Stop
6 = Maximum memory or Low Battery Stop
If no value follows command, prompts will be displayed for the value. After
setting a stop condition of Depth, Time/Date or Number of Samples, use
STOPDATA to enter an appropriate parameter value.
Example:
input: SP 5
output: New Stop Condition Setting: Fixed Number Stop
PD
Set Stop Condition Data
Syntax:
PD x or STOPDATA x where x is the stop condition data as described
below
Description:
The PD command sets the stop condition data to be used when the
collection data. The stop condition data is used with the Stop Condition
settings as follows.
• If the Stop Condition is Depth Stop (option 1) the input will be stop
depth in meters.
• If the stop condition is set to Time/Date Stop (option 2) the input for
PD will be the stop date and time.
• If the Stop Condition is Fixed Number Stop (option 5) the input will
be the number of samples to collect before stopping.
• The PD setting is ignored for Mechanical Switch Stop (option 3),
Digital Input Stop (option 4) or Maximum memory or Low Battery
Stop (option 6).
Example:
input: PD 3 (if Stop Condition =1 (Depth Stop))
output: New Stop Condition data = 3
Stop Condition: Depth Stop at 3 meters
input: PD 2016/12/31 23:59:59 (if Stop Condition = 2 (Time/Date Stop))
output: New Stop Condition data = 2016/12/31 23:59:59
Stop Condition: Time Stop at 2016/12/31 23:59:59

Sequoia LISST-200X Specifications

General

Brand	Sequoia
Model	LISST-200X
Category	Measuring Instruments
Language	English