SEREN R301 - CEX in Connector; CEX out Connector

R301 RF POWER SUPPLY OPERATOR’S MANUAL
Connect the supplied power cord to the power inlet and connect to mains power.
If the power cord is lost or damaged, replacement cords are available
from Seren IPS Inc. or can be purchased locally. When purchasing a
power cord from a local vendor, ensure the replacement cord is of the
same wire gauge, current handling capacity, and voltage rating.
3. Mains Circuit Breaker:
Set to the “1” position to enable, set to the “0” position to disable. To reset the circuit
breaker, set the handle to the “0” position, then to the “1” position
4. DCP Connector (optional)
Voltage Probe Inverter Input. Analog input, 0 to –10VDC input range.
Connector: Type BNC Female
Input Impedance: 100K Ohm
Option. Permits the R301 to use a negative polarity voltage probe signal from a passive
probe (such as an MM-Series or PM-Series matching network) for external RF output
regulation feedback (voltage control). Connect a negative polarity probe signal to the
DCP connector and connect Analog Interface connector pin 25 (INVPROBE output) to
Analog Interface connector pin 24 (FEEDBACK input).
5. CEX OUT Connector
Common EXciter output: 5 to 8V Peak-to-Peak, 13.56MHz.
Connector: Type BNC Female
In “Master” mode, the common exciter output signal is present at all times regardless of
the RF output state. In “slave” mode, the common exciter output signal is present when
there is a signal present at the CEX IN connector.
In “Master” mode, the common exciter output frequency is the same as the programmed
frequency. In “Slave” mode, the common exciter output frequency is the same as the
signal at the CEX IN connector.
6. CEX IN Connector
!
Common Exciter input; 3 to 8V Peak-to-Peak sine wave, 13.56MHz.
Connector: Type BNC Female
Page 35
Seren IPS Inc.
6100130000 Rev. 0.05