SEREN R301 - Rear Panel Connections (continued); Power, Exciter, and DCP Connectors

R301 RF POWER SUPPLY OPERATOR’S MANUAL
Rear Panel Controls and Connections
4
6
5
2
1
7
3
9
A
A
N
1
CEX
OUT
CEX
IN
O
G
L
L
POWER
RF OUT
A
R
E
I
S
!
DCP
8
1. RF Output
Type “N” female RF connector. Connect a 50-Ohm coaxial cable from the RF Output
connector to a 50-Ohm load (50-Ohm 300 Watt resistive load, impedance matching
network, impedance matching transformer, plasma chamber, or other processing
apparatus). The center pin of the connector is RF “hot”, connector shell is RF return.
2. Power Inlet
Power Inlet Connector: IEC320 type male, filtered.
Mating Cord Connector: IEC320-C13.
CAUTION: UNLESS OTHERWISE SPECIFIED, THE R301 RF POWER SUPPLY
IS SHIPPED FROM THE FACTORY CONFIGURED FOR 115 VOLT OPERATION.
CHECK YOUR MAINS VOLTAGE AND THE LINE VOLTAGE PRINTED ON THE
RATINGS PLATE OR CONSULT A QUALIFIED ELECTRICIAN BEFORE
CONNECTING THE R301 RF POWER SUPPLY TO MAINS POWER.
CONNECTING TO THE WRONG MAINS VOLTAGE MAY DAMAGE THE R301
RF POWER SUPPLY AND VOID THE WARRANTY.
Page 34
Seren IPS Inc.
6100130000 Rev. 0.05