R301 RF POWER SUPPLY OPERATOR’S MANUAL
Safety Notes
POINT
EQUIPOTENTIAL BONDING
!
GROUND
=
PROTECTIVE
= CAUTION
=
HIGH
VOLTAGE
=
RADIO FREQUENCY
ENERGY HAZARD
=
The R301 RF Power Supply has been designed and tested to meet strict safety requirements.
These include independent lab examination and approval, and compliance to established
standards. Please read the following instructions carefully before operating the R301 RF Power
Supply and refer to them as needed to ensure the continued safe operation of the R301 RF Power
Supply.
Follow all warnings and instructions marked on or supplied with the product.
Symbology:
Unplug or disconnect this equipment from the power source before cleaning or re-configuring
the AC mains voltage.
Do not use this equipment near water, wet locations, or outdoors.
Do not place this equipment on an unstable cart, stand, or table. The R301 RF Power Supply
may fall, causing personal injury or damage to the R301 RF Power Supply .
This product is equipped with a 3-wire power cord and grounding type plug. This is a safety
feature. To avoid electric shock, this unit must be connected to the power source in compliance
with the National Electrical Code ANSI C1 and/or any other codes applicable to the user.
Improper installation may result in a shock or fire hazard.
It is the responsibility of the installer to provide a proper protective ground from the R301 RF
Power Supply to earth ground, in accordance with local and national electrical codes, and any
other codes applicable to the user.
R301 RF Power Supply should be operated from the type of power source indicated by the
ratings plate. If you are not sure of the type of power available, consult an electrician or your
local power company.
The power supply cord and plug is the disconnect device for this equipment. If the plug is
removed from the cord and the power cord is hard wired to the power source, it is the
responsibility of the installer to provide a disconnect device.
Do not allow anything to rest on the power cord or interconnecting cables. Do not locate the
R301 RF Power Supply where persons will step on the power or interconnecting cables.
Slots and Openings in the equipment’s chassis are provided for ventilation. To ensure reliable
operation of the R301 RF Power Supply, these openings must not be blocked, covered, or
restricted. Restricting the air inlets or exhaust will cause the unit to overheat. Sustained over
temperature conditions may degrade or damage the unit.
Page 3
Seren IPS Inc.
6100130000 Rev. 0.05
To Next Page
Loading...