Setra Systems Flex - Output Settings

To Next Page

To Previous Page

Output Settings

An external device can be connected to a FLEX-RC unit: at

the back of the main unit The FLEX main unit supports 1

analog output and 1 relay output.

Outputs that are on-board the FLEX main unit are labeled

“On-Board” Outputs and Relays.

Select the desired Output or Relay to be congured.

Thendene the type of signal FLEXwill generate to the

destination controller or equipment.

Choose the Data Source from which to obtain this signal

value. This can be any of the FLEX three (3) rooms, and

any of the six (6) parameters at each room. If this is a

Control application, choose one of the four (4) Control

Loops available in FLEX-RC. Examples appear below:

Data Source can be selected as one of the following:

• None–theOutputTypehasbeendened,butnodata

source is feeding a signal

• Room 1 Pressure – the Output is driving a signal from

Room 1 Pressure badge

• Room 1 Temperature – the Output is driving a signal

from Room 1 Temperature badge

• Room 1 Humidity – the Output is driving a signal from

Room 1 Humidity badge

• Room 1 ACH – the Output is driving a signal from Room

1 Air Changes per Hour (ACH) badge

• Room 1 User Dened – the Output is driving a signal

fromRoom1’srstUserDenedbadge

• Room 1 User Dened – the Output is driving a signal

fromRoom1’ssecondUserDenedbadge

• Room 2 Pressure – the Output is driving a signal from

Room 2 Pressure badge

• Room 2 Temperature – the Output is driving a signal

from Room 2 Temperature badge

• Room 2 Humidity – the Output is driving a signal from

Room 2 Humidity badge

• Room 2 ACH – the Output is driving a signal from Room

2 Air Changes per Hour (ACH) badge

• Room 2 User Dened – the Output is driving a signal

fromRoom2’srstUserDenedbadge

• Room 2 User Dened – the Output is driving a signal

fromRoom2’ssecondUserDenedbadge

(CONTINUED ON NEXT PAGE)

Operation

Other manuals for Setra Systems Flex