7
Operation
DynaStop® in conjunction with STO
Operating Instructions – MOVIGEAR
®
performance
143
27021619739106059
With the configured digital input/process data bit, you can do the following:
• Deactivate the DynaStop
®
function of MOVIGEAR
®
performance without deactivat-
ing drive enable in function block FCB01.
7.5 DynaStop
®
in conjunction with STO
DynaStop®
in
conjunction
with STO
WARNING
The DynaStop
®
electrodynamic retarding function does not allow for a definite stop
at a position.
Severe or fatal injuries.
• DynaStop
®
must not be used for hoists.
• When DynaStop
®
is used on inclining/downward slopes or for vertical conveyors
without free hanging loads, adhere to the basic safety and health requirements
(e.g. the EG Machinery Directive 2006/42/EG).
• To use DynaStop
®
, perform a risk assessment to determine the required safety
measures.
INFORMATION
Observe chapter "Functional safety" for using the STO function.
The optional DynaStop
®
function is not safety-related. It is not part of the safety func-
tions described in chapter "Functional safety".
25945475/EN – 04/2019
To Next Page
Loading...
Need help?
General
