SEW-Eurodrive MOVIPRO PHC21A-A075M1-E45C-C5

To Next Page

To Previous Page

Mechanical installation

Assembly

Operating Instructions – MOVIPRO

PHC2.A-A..M1-E45C-C5

Mounting the device

The following figure provides an overview on the mounting of the device:

[1][2]

[4]

[3]

9007209052494859

[1] Holding fixture, e.g. square pipe with an edge length ≤32mm

[2] Bore for M6 screw

[3] M6 screw of an appropriate length with washer

[4] M6 screw of an appropriate length with washer

Procedure

1. Use the mounting brackets to hang the device on the holding fixture [1].

2. Attach the mounting brackets to the holding fixture [1] with M6 screws [3] in appro-

priate length.

3. As an alternative you can attach the mounting brackets from above using M6

screws [4].

26596598/EN – 10/2020

SEW-Eurodrive MOVIPRO PHC21A-A075M1-E45C-C5 - Page 52